Enabling Hik-Connect on the recorder GUI 3.0. 1) Right-click and select Menu and then browse to Configuration > Network > Platform Access. 2) Tick the Enable box. You will then be prompted to create a Verification Code, set this as something memorable, and please make a note of it as you will need it again shortly.
The answer turns out to simply be that the remote control cannot be used in this mode. It supposedly can only can be used in HDMI Live View video output. I do not know about VGA Live View video output mode. I was told by Hikvision tech support that the reason is, is that in CVBS (Composite A/V) mode the text on the menus would be so poor and
You can then access the recordings and live view after connecting the camera to a monitor. If you want remote viewing, connect the camera system with a router. How to Find Your IP Camera Address: 4 Easy Ways. Here are 4 options you can find the IP address of a camera. #1. Find the IP camera address via the security camera companion software

Navigate to Configuration > Image and then OSD Settings tab. Configure the display to your own requirements and make sure that Display Date is ticked at least. Click save and check out the Live View feed to ensure that the timestamp is correct. That’s all you’re done. The NVR will automatically synchronize the timestamp and you’ll always

I can view it using HikConnect on my phone. But it is not listed for main (live) view or remote playback in iVMS-4200 on my PC (5x analogue cameras and a Channel-zero show just fine). It does show in basic configuration (iVMS-4200 Maintenance and Management): listed under 'camera management - ip camera' (its entry in the 'connect' column is blank);

You will need to open up the following ports : HTTP Port = 80. Server Port = 8000. RTSP Port = 554. HTTPS Port = 443. It is only necessary to open TCP ports from the above range as Hikvision products do not use UDP for communications. We would advise that you turn off the ‘Enable DHCP’ functionality from within the DVR / NVR and also untick

Perform further operations such as live view, playback, and access control. Notes: See Live View for details about live view. See Remote Playback for details about remote playback. See Managing Security Control Panel for details about setting partition status and zone management such as adding zone, setting zone bypass, and linking camera.
Modified on: Thu, 26 Jan, 2023 at 4:53 PM. Question: iVMS is asking to change ports ISUP ports. Answer: If iVMS is asking to change ISUP port when starting up iVMS up, then change the port to 8085, 9080, 8060, or 8070. aSR21.
  • 090ipf7hce.pages.dev/480
  • 090ipf7hce.pages.dev/190
  • 090ipf7hce.pages.dev/345
  • 090ipf7hce.pages.dev/35
  • 090ipf7hce.pages.dev/366
  • 090ipf7hce.pages.dev/404
  • 090ipf7hce.pages.dev/478
  • 090ipf7hce.pages.dev/18

    • can t access hikvision live view